Sauna Kota Inari
Sauna Kota Inari
For sauna room volume: 8-18 m3
Sauna oven Kota Inari
The sauna is not included!
Kota sauna stoves meet all the requirements for a good sauna stove.
Large amount of stone guarantees effective bathing.
The round shape of the furnace body and outer shell extends the product's life because the furnace can better withstand the load from the heat expansion, which is now evenly distributed throughout the body. In addition, the round shape facilitates placement in confined spaces and corners. The outer casing of the oven is made of black lacquered steel sheet.
Kota on wood-fired sauna heaters is marked with quality
Kota Inari is a sauna oven with its own touch. This new grille product with strong construction provides enjoyable and long sauna baths even for a frequent sauna bathers. The stones that are visible thanks to the grid give the sauna oven a pleasant appearance. The old Kota L and new Luosto sauna stoves can be transformed into a representative Inari sauna stove thanks to the stone grille, which can be purchased as an accessory. A good wood-fired sauna heater like Kota sauna has minimal maintenance.
Kota sauna has created a reputation for wood-fired sauna heaters that is the brand quality simply.
The environmentally friendly sauna heater is heated with a relatively small amount of wood. The sauna oven has a glass door with cast iron frame and adjustable feet.
NOTE! When you have a wood-fired oven you must have a floor protection plate. Available under accessories above. This does not apply to you who have cast concrete slab or equivalent. If you have underfloor heating in the sauna, floor protection plate is required.
Kota sauna is a very good wood-fired sauna heater for those who want minimal maintenance.
It is possible to connect the chimney upwards and backwards, dimensions from floor up to the rear chimney hole are 840 mm, measured from the lower edge of the duct. It is also possible to cut three steel wires in the stone basket eg. with an arch file. Then the dimension becomes 550 mm.
SS-EN 15821: 2010 is a harmonized EU standard with regard to sauna heaters for piece wood and gives rise to CE marking according to CPR. It specifies the emission limit value 1.0% CO at 13% O2.
From July 1, 2013, declared properties and CE marking must be available for construction products covered by a harmonized standard, and marketed within the EU, all in accordance with the Construction Product Regulation.
Accessories such as chimney, base chimney, floor protection plate, wall protection plate can be found under accessories above.